Bike Headtube Headlight Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this to mount a headlight to my bicycles headtube instead of the handlebars. I don't like the light to move all…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 628
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I made this to mount a headlight to my bicycles headtube instead of the handlebars. I don't like the light to move all over as i steer. The bolt hole to mount the light on this is 8mm.The headtube on my bike is about 42mm wide. I left some room in there so that i could put some foam tape to prevent this from scratching the paint, but to also give it a little traction. The only thing that holds it on is a single zip tie. The headlight i have is probably on the bigger side of what you are going to be using with a bicycle, and this, and the single zip tie, seem to be holding up very well.
I know enough about bikes to know that all headtubes are not the same size, but I imagine you can scale this as needed. Mine is a 29" mountain bike with a threadless fork. I made this for my bike specifically, but i thought i would post it here just in case someone else can make use of it.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.32
Infill:
40
Filament:
3d Solutech PLA
Notes:
supports shouldn't be needed. print in current orientation.
Category: Hobby