1 / 5
N4Plus Voron Mantis with Knomi Revamp V2 + VZ-HextrudORT Extruder + AD5XHotend + BTT-EBB42 + BTT-Eddy — zdjęcie 1
1 / 5

N4Plus Voron Mantis with Knomi Revamp V2 + VZ-HextrudORT Extruder + AD5XHotend + BTT-EBB42 + BTT-Eddy

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Another better version of quick nozzle swap toolhead using AD5X Hotend

Ocena
0 / 5
Polubienia
3
Pobrania
10
Wydruki
0
Wyświetlenia
203
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This toolhead design is for sensorless homing & quick nozzle swap using AD5X Hotend better than E3D Revo Nozzle.

Why i said it's better than E3D Revo Nozzle? When until certain usage, the nozzle started to have some filament leakage & leak until the screw part or Revo Heater Core part. That's make you hard to unscrew it when it's cooldown.

For AD5X Hotend, you don't need to unscrew anything, not even the heatsink. Before dismantle the nozzle, you must unload the filament, wait for hotend to cooldown. Once it's all cooldown till 60°C & below, you may start to unlock the heatsink & open the nozzle latch then VOLLA!! your nozzle is out from hotend. You can either place back the same nozzle after cleaning it or replace new nozzle to print.

Extruder Offset:
X: -9
Y: -10

The filament sensor i use for this toolhead is as link below:
https://www.printables.com/model/1271021-filament-sensor-endstop-switch-vz-hextrudort-plus


Happy Printing.

Tagi