1 / 5
Forge Motorsport open/ram-air adapter for Swift Sport (ZC33S) or compatible — zdjęcie 1
1 / 5

Forge Motorsport open/ram-air adapter for Swift Sport (ZC33S) or compatible

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replaces the stock cap in on the Forge Motorsport intake to allow open air or partial ram air

Ocena
0 / 5
Polubienia
6
Pobrania
10
Wydruki
0
Wyświetlenia
330
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

Uses the Forge Motorsport carbon tube style intake which may work on other vehicles as well. 

The cap allows for partial open-air and then cold air when there's positive pressure through the pipe. The original silicon tube can be used or generic flexible intake ducting or just without for a bit more turbo sounds but probably at the cost of hotter air.

This is probably only effective when positive pressure is achieved - I designed a separate fog-light intake duct to match up with this and force in air while not causing a restriction at low RPM/Speed through the long tubing.

It was originally designed along-side this fog-light duct intake:

Installation

  • Remove the existing screws from original metal cap and take it out

  • Insert the new intake and mark the holes

  • Take out and drill pilot holes for the original screws

  • Reinsert and screw in

  • Attach pipe (optional)

    • This may require some fiddling as I made it quite tight to keep it in place

    • Clamp/zip-tie it if you feel it's needed, I generally haven't needed to

Print Settings

  • Material: A reasonably high temperature material, anything ABS, PETG upward seems fine

  • Wall Thickness: 3-5 sidewalls with low-ish infill - the structure seems relatively strong and low infill provides better insulation, although that probably doesn't have much impact in this case

  • Layer-height: I went with 0.25 for most of the bottom layers and then smaller adaptive layers at the top to make it smoother

  • Supports: None required, just print flat side down

The Fusion 360 model is included with most measurements defined as parameters if you'd like to tweak it.

Any feedback welcome.

Tagi