1 / 5
Forge Motorsport open/ram-air adapter for Swift Sport (ZC33S) or compatible — image 1
1 / 5

Forge Motorsport open/ram-air adapter for Swift Sport (ZC33S) or compatible

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replaces the stock cap in on the Forge Motorsport intake to allow open air or partial ram air

Rating
0 / 5
Likes
6
Downloads
10
Makes
0
Views
330
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution

Uses the Forge Motorsport carbon tube style intake which may work on other vehicles as well. 

The cap allows for partial open-air and then cold air when there's positive pressure through the pipe. The original silicon tube can be used or generic flexible intake ducting or just without for a bit more turbo sounds but probably at the cost of hotter air.

This is probably only effective when positive pressure is achieved - I designed a separate fog-light intake duct to match up with this and force in air while not causing a restriction at low RPM/Speed through the long tubing.

It was originally designed along-side this fog-light duct intake:

Installation

  • Remove the existing screws from original metal cap and take it out

  • Insert the new intake and mark the holes

  • Take out and drill pilot holes for the original screws

  • Reinsert and screw in

  • Attach pipe (optional)

    • This may require some fiddling as I made it quite tight to keep it in place

    • Clamp/zip-tie it if you feel it's needed, I generally haven't needed to

Print Settings

  • Material: A reasonably high temperature material, anything ABS, PETG upward seems fine

  • Wall Thickness: 3-5 sidewalls with low-ish infill - the structure seems relatively strong and low infill provides better insulation, although that probably doesn't have much impact in this case

  • Layer-height: I went with 0.25 for most of the bottom layers and then smaller adaptive layers at the top to make it smoother

  • Supports: None required, just print flat side down

The Fusion 360 model is included with most measurements defined as parameters if you'd like to tweak it.

Any feedback welcome.

Tags