Snapmaker U1 Squashball feet mashup / remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of DeSkwared's Snapmaker U1 feet & schnub0mat's X1 squashball feet - to further dampen the U1's acceleration.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Due to the excessive vibrations from the U1's acceleration, dampening with squashballs has been a great addition (and also slowing the Z-hop to 200mm/sec from 500mm/sec+). All recalibrations performed for vibrations/alignment worked as expected.
Utilized 64D TPU with 40% infill, provides proper rigidity and flexibility with double yellow dot squashballs. No supports or brim needed as overhangs aren't severe. Printed at .16mm layer height in about 1.5 hours each, or ~6.5 hours for all 4 at once (no issues) - used base U1 PEI plate and no adhesive needed to slip fit into the U1 due to the snug fitment of DeSkwared's OG model. You could print out your own squashballs to use with this, YMMV.
I also built a 70# baseplate under the U1 in my BROR rack out, of tiles to help provide a firm anchor for the printer to sit on, with a ½ neoprene mat underneath.