Covers and Spacers for various cutouts in bathroom cabinets

Covers and Spacers for various cutouts in bathroom cabinets with a wall thickness of 16.5 mm.

Cover for the cutout beneath the sink drain pipe

• Model: Cut-Out-Cover-B1-D16.8-Dia100

  • Suitable for: Maximum washbasin drain diameter: 90 mm

• Stencil: Stencil-B1-DIA100.stl

  • The stencil diameter is 0 mm larger than the nominal diameter of the recess. Therefore, you should add about 2 mm of extra space around the cutout for the adhesive. Take a look at the image ‘Stencil-B1-DIA100(white)_Cut-out(red).png’ for reference.

• Print recommendations:

  • print in PLA (I used 'Das Filament PLA red')

  • Nozzle: 0,4 mm

  • Layer height: 0.20 mm

  • Perimeter: 2

  • Infill: 100%

  • Support: For support enforcers only (paint on support)

  • Brim: no

Bathroom cabinet cut-out cover for hose with 26 mm diameter

Can be used, for example, to guide a drain hose or water inlet hose through the side wall of the bathroom cabinet by the shortest route. In my case, the hose would be too short to connect it to the drain via the longer route from the bottom of the washbasin cabinet. Only the direct route, through the side wall, was possible.

• Model: Cut-Out-Cover-D16-Dia35-Abwasserschlauch-Dia26.3.stl

  • Suitable for:

    • Maximum cabinet wall thickness: 16.5 mm

    • Suitable for hoses with a diameter of up to 26 - 27 mm (Nominal tube diameter: 26.3 mm)

• Stencil: Stencil-A1-DIA35-Abwasserschlauch-Dia26.3.stl

• Print recommendations:

  • Material: PLA

  • Layer height: 0.2 mm

  • Perimeter: 2

  • Infill: 100%

  • Support: yes

  • Brim: No

Spacer for bathroom cabinet corner

My bathroom cabinet is mounted on the wall. The corner spacer compensates for the gap to ensure it is aligned straight.

• Model: Rear-Corner-Spacer-8mm-for-panel-thickness-16.5mm.stl

  • Suitable for:

    • Maximum cabinet wall thickness: 16.5 mm

    • Suitable for hoses with a diameter of up to 26 - 27 mm (Nominal tube diameter: 26.3 mm)

• Print recommendations:

  • Material: PLA

  • Layer height: 0.2 mm

  • Perimeter: 3

  • Infill: 10%

  • Support: No

  • Brim: No

• Installation: In my case, I simply snap the spacer onto the bottom of both rear corners.

  This provides an additional 8 mm of clearance from the wall.

Happy 😊 creating usefull stuff 👍

Updates