Rear Ventilation duct for FlashForge AD5M/5M pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear duct for the AD5M, adding PRO feature to a regular 5M
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 493
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
It uses a mounting for a 5015 24V fan, though a lower voltage fan and regulator can work
I liked this type of duct, but all had the flapper used by the PRO motherboard.
Several printed the duct closed, and if supports were used, cleaning out the supports would be a nightmare.
I wanted the cover to be removable for easy service.
Many non-PRO do not have the servo motor connections on the Motherboard, SO i removed the flapper from the design.
For assembly, I used 11 plastic type awgar screws 2.5-3 mm Dia. x 10 mm.
NOTE: The holes in the cover are intentionally covered with a .05mm layer, so no supports are needed around the holes. Push them through after printing.