1 / 7
Sink-Rim Sponge Tray — Hooks Over the Rim, Drains Into the Basin — zdjęcie 1
1 / 7

Sink-Rim Sponge Tray — Hooks Over the Rim, Drains Into the Basin

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Single-bay sponge tray that hooks over a kitchen sink rim and hangs inside the basin.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
28
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

A single-bay sponge tray that hooks over the rim of a kitchen sink and hangs the tray inside the basin. Sized to a standard kitchen sponge (~95 × 60 × 25 mm) with ~5 mm slack on every side, snug enough to keep the sponge in place but loose enough to slide in wet. Floor drain slots and lower-wall drains let water run straight back into the basin so the sponge dries between uses.

Geometry

  • Tray — 100 × 65 × 28 mm inner volume.

  • Floor drains — long parallel slots in the floor, parallel to the rim direction. Drips fall straight through.

  • Side / front / back drains — 32 mm horizontal slots near the floor of every wall so the sponge isn't sitting in a sealed pool.

  • Hook clamp — back wall extends up and over the sink rim, then drops a second leg back down to bed level. The two legs grip a rim about 6 mm thick (typical drop-in stainless rim). The outer leg doubles as an external water-runoff surface.

Print

  • Orientation: open top UP. The outer hook leg drops all the way to bed level so the whole print sits flat on the bed.

  • Supports: none required.

  • Layers: 0.2 mm.

  • Walls: 3.

  • Infill: 15 %.

  • Filament: ~80 g PLA.

OpenSCAD source included

Everything is parametric at the top of sink_sponge_tray.scad — the sponge footprint, wall thickness, drain slot sizes, and most importantly rim_grip_thickness (the gap between the back wall and the outer leg). Print a test hook first if your rim is unusual; the default 6 mm fits most drop-in stainless sinks.

Tagi