Sink-Rim Sponge Tray — Hooks Over the Rim, Drains Into the Basin
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Single-bay sponge tray that hooks over a kitchen sink rim and hangs inside the basin.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 28
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
A single-bay sponge tray that hooks over the rim of a kitchen sink and hangs the tray inside the basin. Sized to a standard kitchen sponge (~95 × 60 × 25 mm) with ~5 mm slack on every side, snug enough to keep the sponge in place but loose enough to slide in wet. Floor drain slots and lower-wall drains let water run straight back into the basin so the sponge dries between uses.
Geometry
Tray — 100 × 65 × 28 mm inner volume.
Floor drains — long parallel slots in the floor, parallel to the rim direction. Drips fall straight through.
Side / front / back drains — 32 mm horizontal slots near the floor of every wall so the sponge isn't sitting in a sealed pool.
Hook clamp — back wall extends up and over the sink rim, then drops a second leg back down to bed level. The two legs grip a rim about 6 mm thick (typical drop-in stainless rim). The outer leg doubles as an external water-runoff surface.
Orientation: open top UP. The outer hook leg drops all the way to bed level so the whole print sits flat on the bed.
Supports: none required.
Layers: 0.2 mm.
Walls: 3.
Infill: 15 %.
Filament: ~80 g PLA.
OpenSCAD source included
Everything is parametric at the top of sink_sponge_tray.scad — the sponge footprint, wall thickness, drain slot sizes, and most importantly rim_grip_thickness (the gap between the back wall and the outer leg). Print a test hook first if your rim is unusual; the default 6 mm fits most drop-in stainless sinks.
