Dapol O Gauge 08 Ladder Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A jig to aid with the assembly of the front ladder for the Dapol O gauge Class 08 shunter
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
This is a jig to aid with the assembly of the front ladder for the Dapol O-gauge Class 08 shunter.
Print in resin with your normal settings. The holes are modelled 0.8mm to fit the 0.75mm rungs, but will likely print undersize. Clean them out with a 0.8mm drill before curing, but don't make the holes any deeper.
The jig will allow you to assemble one side of the ladder. Glue each rung in place with a tiny drop of thin cyanoacrylate - I use a cocktail stick to pick up a drop and place it exactly so it flows in to the joint. Check all the rungs are seated in the ladder sides before glueing. Once all the runs are glued in place, carefully lift the ladder out of the jig, then you can flip it over and glue the other side.
I attached the completed ladders on to the model with 0.4mm brass wire, again glued in place using the same technique.
Please note, I'm not affiliated with Dapol, just a happy customer who likes their models :)