1 / 5
Protective inlay for Feedback Sports RAKK bicycle stand — zdjęcie 1
1 / 5

Protective inlay for Feedback Sports RAKK bicycle stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Protective inlay gives a better fit to my bicycle tyre, and reduces pressure from sharp metal sheet edges

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
91
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution — Noncommercial

Seeing the tyre on the edge of a 1 mm sheet metal bike stand hurts me an damages the tyre, when the air pressure is dropping. I found a inlet to solve this, but for my stand model i hat to trim the rear edges. Now it slides easliy on the stand.

I also changed the small lower radius to 15 mm to fit my 28 mm tyres.

Both -rear an front on the stand- are equal. You have to print two pieces.

I printed it topside down with standard profile, supports actived.

I used PETG, but any material should fit.

Tagi