1 / 5
Protective inlay for Feedback Sports RAKK bicycle stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Protective inlay gives a better fit to my bicycle tyre, and reduces pressure from sharp metal sheet edges
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 93
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial
Seeing the tyre on the edge of a 1 mm sheet metal bike stand hurts me an damages the tyre, when the air pressure is dropping. I found a inlet to solve this, but for my stand model i hat to trim the rear edges. Now it slides easliy on the stand.
I also changed the small lower radius to 15 mm to fit my 28 mm tyres.
Both -rear an front on the stand- are equal. You have to print two pieces.
I printed it topside down with standard profile, supports actived.
I used PETG, but any material should fit.