1 / 4
Climbing clip stick - (Betastick Clipstick Replacement) — zdjęcie 1
1 / 4

Climbing clip stick - (Betastick Clipstick Replacement)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement Head with Spring for the Betastick Clipstick 12mm Pole.

Ocena
5 / 5
Polubienia
7
Pobrania
74
Wydruki
0
Wyświetlenia
507
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

A friend of mine had problems with the spring steel wire of the beta clipstick, so I searched for an alternative and created this replacement a while ago.

Installation :

  • File down any sharp printing artifacts or edges, so no textile climbing gear can be damaged!

  • Drill out the rivet of the original head

  • Increase if needed the hole to fit the 4 mm bolt

  • Check alignment of the hole to the new head

  • use M4x20mm cylinder head bolt and nut (width of part is 19 mm)

  • Move the clip part over head part, then bend the back latch slightly to fit the clip in the slot.

The design is not perfect sometimes the back of the head breaks if the rope/clipstick is stuck, and you pull too hard to get it free.

Fits all tested carabiners, dmm, ocun, petzl most wiregates and many screwgates as well.

Printed in PETG:

  • 0.20 mm layer height

  • 6 perimeters

  • 25% infill - honeycomp

  • solid layer 5 top/bottom

  • supports depends on printer

Tagi