1 / 4
Climbing clip stick - (Betastick Clipstick Replacement) — image 1
1 / 4

Climbing clip stick - (Betastick Clipstick Replacement)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement Head with Spring for the Betastick Clipstick 12mm Pole.

Rating
5 / 5
Likes
7
Downloads
74
Makes
0
Views
507
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

A friend of mine had problems with the spring steel wire of the beta clipstick, so I searched for an alternative and created this replacement a while ago.

Installation :

  • File down any sharp printing artifacts or edges, so no textile climbing gear can be damaged!

  • Drill out the rivet of the original head

  • Increase if needed the hole to fit the 4 mm bolt

  • Check alignment of the hole to the new head

  • use M4x20mm cylinder head bolt and nut (width of part is 19 mm)

  • Move the clip part over head part, then bend the back latch slightly to fit the clip in the slot.

The design is not perfect sometimes the back of the head breaks if the rope/clipstick is stuck, and you pull too hard to get it free.

Fits all tested carabiners, dmm, ocun, petzl most wiregates and many screwgates as well.

Printed in PETG:

  • 0.20 mm layer height

  • 6 perimeters

  • 25% infill - honeycomp

  • solid layer 5 top/bottom

  • supports depends on printer

Tags