Makita metric socket set holder, for portability.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed this to replace the OEM rubber holder as mine were wearing out.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed to replace the original set holder as mine were wearing out.
Printed out of Sunlu petg, 4 walls, 15% infill. has been holding up for the last couple months of daily use very well.
For assembly you will need an M3x.5 tap, m3 bolt roughly 15mm length or longer, for the hinge point in the latch, tap the smaller diameter hole of the latch before bolting together. you also may want to add a nylock nut on the back to keep it from loosening. An m5x.8 bolt 30mm length for main pivot, and a nylock nut for that. also has holes in the bottom of each slot for m10x2 magnets to be glued in if desired.
Designed for the makita socket set, holds:10mm, 12mm, 13mm, 14mm, 15mm, 17mm, 18mm, and 21mm. Didn't add a slot for the 8mm as i dont often use it.