XShot Ejector Bolt Link
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement part for the piece in the Xshot Ejector's bolt that connects the bolt handle to the rest of the pusher mech
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
This piece snapped on my xshot ejector when i was trying to find some limits of its performance, so I made a new piece that should be stronger. Printed flat because if you print it vertically it would likely snap in the same manner. Use supports for the long tube-ish section at the end, and make sure to print with lots of walls to keep it as durable as possible (I typically do 5). There is a hole meant for using an m3x8 screw in order to keep the two halves together while you epoxy/glue them (if you use a flat head screw you can likely keep the screw in, however the more typical socket heads will stop the bolt handle from rotating if you leave it in).
step included for anyone who thinks they can make improvements on it. I am not sure why, but since installing this replacement i have lost the "click" that the bolt would make previously when it would be rotated.