Flow through supressor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My First supressor Design for 9mm air guns with 16mm od Barrel. Needs an extra setscrew clamp
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 371
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Open Community License v1
First draft and prototype.
* Design: over-barrel (reflex) suppressor for a 16mm barrel. No external metal or carbon sleeve required.
* Mounting Interface: Rear base interfaces with a round shaft clamp featuring a 50mm outer diameter and 16mm inner bore.
* Internal Structure: Gas routes into a rear chamber, moving forward through 10 parallel 360-degree helical channels. Angled slots connect the inner baffles to the outer helix.
* Mounting Holes: No pre-made holes or pockets for heat-set inserts are included in the CAD file due to varying bolt circle dimensions on commercial clamps.
* Printing Requirement: A wide outer brim of 30 mm is required to ensure bed adhesion for the tall, vertical geometry. And Print Front down