Flow through supressor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My First supressor Design for 9mm air guns with 16mm od Barrel. Needs an extra setscrew clamp
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 61
- Makes
- 0
- Views
- 371
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Open Community License v1
First draft and prototype.
* Design: over-barrel (reflex) suppressor for a 16mm barrel. No external metal or carbon sleeve required.
* Mounting Interface: Rear base interfaces with a round shaft clamp featuring a 50mm outer diameter and 16mm inner bore.
* Internal Structure: Gas routes into a rear chamber, moving forward through 10 parallel 360-degree helical channels. Angled slots connect the inner baffles to the outer helix.
* Mounting Holes: No pre-made holes or pockets for heat-set inserts are included in the CAD file due to varying bolt circle dimensions on commercial clamps.
* Printing Requirement: A wide outer brim of 30 mm is required to ensure bed adhesion for the tall, vertical geometry. And Print Front down