Glow-in-the-Dark Firefly Fridge Magnet (Press-Fit, 3x2mm Magnets)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cute 2-part press-fit firefly fridge magnet. Uses 3x2mm magnets. Print the lantern with glow-in-the-dark filament!
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 129
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Bring a little bit of nighttime magic to your kitchen with this stylized Firefly Fridge Magnet!
This cute, two-part 3D model is designed as a functional and decorative refrigerator magnet. To achieve the perfect glowing effect, the design separates the main body from the abdomen (the lantern), allowing you to print the tail section with glow-in-the-dark filament.
🪛 Technical Specifications & Hardware
Magnet Size: Designed for standard round neodymium magnets with a diameter of 3 mm and a height of 2 mm.
Assembly: Fully press-fit design. No glue required for either the magnets or the body parts (depending on your printer's dimensional accuracy and tolerances).
🧱 Model Structure (2 Parts)
The Body: The main structure containing the head, wings, and integrated slots for the 3x2mm magnets at the bottom. (Best printed in black, brown, yellow, or any color of your choice).
The Lantern (Abdomen): A separate snap-on piece. For the intended effect, it is highly recommended to print this part using Glow-in-the-Dark (phosphorescent) filament.
🖨 Recommended Print Settings
Material: PLA, PETG, or ASA.
Layer Height: 0.15 mm or 0.20 mm for optimal tolerances.
Infill: 15% – 20% (Grid or Gyroid).
Perimeters: 2 or 3.
Supports: Not required. The model features clean geometric lines designed to print easily flat on the heated bed.
Note on Tolerances: The tolerances for the magnet pockets and the joint are tight to ensure a secure press-fit. If your printer tends to over-extrude, you might need to adjust your XY Size Compensation (or Horizontal Expansion) by -0.05mm to -0.1mm, or slightly clear the holes with a 3mm drill bit / hobby knife.
🔧 Assembly Instructions
Insert the Magnets: Push the 3x2mm round magnets into the designated circular recesses on the underside of the body.
Attach the Lantern: Align the glowing tail piece with the slot on the main body and gently press them together until they snap into place.
Enjoy: Place it on your fridge, whiteboard, or any magnetic surface, turn off the lights, and watch the firefly glow!
If you like this model, please consider leaving a like, posting a make, and sharing your color combinations! Happy printing!