Recon/Retaliator shroud for MPP

Modified Gemeneye's original Recon barrel recreation to mount on the front of an Xshot MPP.

Used Ghost Manta's shroud as a base for the adapter and to add picatinny rail on top and bottom instead of the original N-strike rails to match the rails on the MPP.

Uses M3x10 screws to bolt together the shroud pieces and an M3x12 screw with nut at the back to pinch the factory collet. The front is held on with a Silly Collet so a 016 o-ring is necessary.

The thin collet  from Sillybutt's SCAR lines up perfectly with the factory barrel. I also included a modified terra bcar that I use. If using a longer barrel, then I would recommend the thin collet to hold the shroud in place and then adding your choice of barrel attachment to the end.

I included a small sight lock to keep to sight in the upright position for the most part, it's not strictly necessary though. The sight can flip up and down like the original and locks into the down position quite well.

Models should be printed in the orientation I've uploaded them in, recommend supports for the bcar and the picatinny rail section.