1 / 7
ESP32 30-Pin Terminal Adapter Mount / Breakout Holder — zdjęcie 1
1 / 7

ESP32 30-Pin Terminal Adapter Mount / Breakout Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clean mounting plate for ESP32 30-pin terminal adapter boards for control systems, WLED, and automation builds.

Ocena
0 / 5
Polubienia
2
Pobrania
64
Wydruki
0
Wyświetlenia
314
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

ESP32 30-Pin Terminal Adapter Mount / Breakout Holder

A clean, functional mounting plate designed specifically for ESP32 30-pin terminal adapter boards.

Originally built to keep wiring organized and secure in small control systems (WLED, lighting control, automation, etc.), this holder provides a simple way to mount your ESP32 breakout while maintaining easy access to all terminals.

Features

* Designed for ESP32 30-pin terminal adapter boards

* Clean mounting solution for permanent or semi-permanent installs

* Standoff design keeps board elevated and protected

* Open layout for easy wire routing and access

* Minimal, functional form factor for clean builds


Compatibility

Designed around this terminal adapter:

https://a.co/d/0bhLEVQS

* ESP32 30-pin breakout boards with screw terminals

* Standard ESP32 DevKit (30-pin layout)

* May fit similar boards with matching hole spacing

Mounting

This plate is designed for simple screw mounting.

* 4x corner mounting holes for securing to a surface

* Uses standard screws (wood screws or M2 depending on your setup)

* ESP32 adapter mounts using integrated standoffs


No inserts required - hardware threads directly into printed standoffs (or use self-tapping screws).

Design Notes

* Raised standoffs prevent shorting against surfaces

* Keeps wiring clean and strain-free

* Designed for quick installs on wood panels, enclosures, or racks

* Works well in control boards, lighting rigs, or bench setups



Print Settings (Recommended)

* Layer height: 0.2 mm

* Walls: 3-4

* Infill: 20-40%


Print flat on the back. No supports required.


Materials

* PLA+: great for indoor control setups

* PETG: better for durability and heat resistance

* ASA: ideal for long-term or enclosed installs


Files Included

*STL (ready to print)

*STEP (for compatibility)

*3MF (for direct print)

*F3D (Fusion 360 source file)

Designed for functional use.

Feel free to modify or adapt for your own setup.


Designed by Jesse @ freejoy.club

Tagi