Toniebox Aftermarket Barrel Jack Charger Dock (Friction Fit)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dock for aftermarket barrel jack charging cable. Friction fit with changeable collar for different DC jacket
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
I obtained some Type C to 9V DC (5x2.1 mm) for use with the TonieBox 1. Due to the location of the charge port, a dock is required. I designed this dock with a removable (and customizable) collar that can friction fit into the dock base.
Additional collars can be printed with a cylinder of approximately 15.8mm OD with a height of 17mm. ID will be dependent on your DC barrel specifications.
Collar (Required): Suitable for DC barrel jack with 11mm max diameter and about 10mm diameter at 17mm from molding edge
Dock: Standard dimension of the official TonieBox 1 Charge dock. 25mm total height.
Dock Tall: Taller dock lower base for aftermarket DC barrel with longer jackets (>22mm). 31mm total height.
Tester: A cut of just the friction fit area. Height as listed.
Installation:
Feed the charge cable through from the bottom of the dock. Attach the collar to the cable. Pull cable back down through the dock. Press down the collar and DC jacket until the top surface is flush. Route the remainder of the cable through the channel.