Gravity trail toy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A toy powered by gravity! (…and a little help from your hand 😜)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
You need to print:
- 1 Base
- 2 Column 1
- 2 Column 2
- 10 trails
- 2 Arches
- 1 spinning Top
Around 80-85 g of PLA
Assembly Instructions
Glue is required.
Place the base on a flat surface. Insert the columns with their supports facing inward. (Refer to the images to see the top and bottom orientation of each column.)
Position the columns so that:
The supports of one Column 1 face the other Column 1.
The supports of Column 2 face the other Column 2.
Glue the arches on top of the columns:
One arch should connect the two Column 1s.
The other arch should connect the two Column 2s.
Glue the trails starting from the top supports. (Use the pictures as a guide for alignment.) The cylindrical supports fit into corresponding gaps in the trails for easy alignment. Glue each trail so that it lines up with the edge of its support.
Finally, if needed, glue the columns securely to the base.
Safety Notice: This toy may contains small parts. Keep out of reach of young children. Do not swallow any pieces. Use with care and under adult supervision.