PNC-50S Nose Cone remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Jack Hydrazine's Estes PNC-50S nosecone he posted on Thingiverse.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
In my version, I tweaked the diameter to exactly match my supply of BT-50 tubes when printed in PETG on a Prusa Core One. I separated the nose cone into its base and the cone itself, splitting the part at the shoulder. This allows the nose cone to be printed with its holder flush to the bed for a sharp demarcation. The nose cone is hollow to allow the addition of modeling clay or other weight as necessary. I created two versions of the base; one that takes a small screw eye and another that has a built in loop for recovery gear attachment. The base with the self-loop weighs less than the base + screw eye. The base is dimensioned to slide into the bottom of the cone and can be cemented in place with epoxy or cyanoacrylate glue.
Print settings for the nose cone were PETG, 0.4mm nozzle, 0.15mm layer height, seams at rear, 2 perimeters, and 0 bottom layers. The nose cone bases were PETG, 0.4mm nozzle, 0.15mm layer height, seams at rear, 2 perimeters, and 5 bottom layers. Supports are not needed, even for the finlets.
If you print all objects at one sitting, I recommend selecting Print Settings / Output Options / Complete individual objects.