Magnus masterkey MPP

A Magnus masterkey for the Xshot MPP, it is based on the geometry of my Retailator shroud remix. It most likely fits other blasters or shrouds with picatinny rail, but the rear filler piece may need adjusting.

I used ScratchCampball's stryfle kit as a base for the rear filler and a mixture of various models to get the picatinny to NERF n-strike rail adapter.

The large holes also act as dart storage.

I used 2 M3x30 screws with nuts, however the do pop out a little on the nut side. I believe M3x25 would be too short, I have not tested this. The hole size is quite tight for the bolt side because I didn't want to have to hold the screws while putting together, so I would recommend loosening them at the same time if you remove it, otherwise it can push out the nuts. 

I included a remix of Corvus's spring spacer, that I modified to act as a shell filler because I didn't like how the plunger tube was open to the elements when you modify the Magnus to be a masterkey.

I also included a modified version of the flared magwell from GhostManta that has the front detailing removed so the the Magnus can fit flush to it.

This is a link to the grip I use, also by Scratch https://www.thingiverse.com/thing:5029036

I don't have any pictures of how I cut the Magnus' slide, however I printed the pump grip and then used that as a guide for my cuts. The cuts to the grip are fairly standard for the type of integration, you just want to take off enough material from the back so that the filler piece ends up sitting flush with the Magnus body.

Reuploaded files for best print orientation. Recommend using supports on the filler piece and the spring spacer.