BMW E39 Facelift Fog Light Mounting Point Repair Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Repair bracket designed to restore the outer fog light mounting point on the BMW E39 facelift (LCI) bumper.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Replaces the integrated plastic tab that commonly shears off, allowing the fog light to be secured without replacing the entire bumper.
The bracket replicates the factory slot geometry. Once bonded, the fog light housing slides into the bracket and locks into place using the original mounting hardware/method.
Material: Would recommend ASA or ABS.
Compatibility: 2001–2004 (Facelift / LCI) BMW E39 5-Series models. Will not fit Pre-Facelift or M-Sport/M5 Bumpers.
I also sell the printed parts:
https://www.etsy.com/listing/4498654078/bmw-e39-facelift-fog-light-mounting
https://www.ebay.com/itm/318242551823
Installation Instructions:
1. Access: Gain access to the fog light assembly either by removing the front splash guard in the wheel well or by removing the front bumper entirely.
2. Alignment: Leave the fog light attached to the bumper by its remaining intact mounting point.
3. Test Fit: Position the repair bracket and verify that it makes flush contact with the bumper surface. Ensure the circular tab on the fog light housing slots correctly into the bracket.
4. Preparation: If remnants of the broken original bracket interfere with the fitment, trim them down until the repair bracket sits flush.
5. Bonding: Thoroughly clean the contact areas on both the bracket and the bumper. Apply a strong epoxy or structural bonding agent to permanently secure the bracket to the bumper.