Snap-On Cable Winder for Cable Management | ZERO Community Accessory
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A snap-on cable winder designed for clean desk setups and portable cable management in backpacks and everyday carry
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 37
- Wydruki
- 2
- Wyświetlenia
- 132
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple snap-on cable winder designed for clean desk setups and portable cable management in backpacks and everyday carry setups.
This accessory was born from two separate community suggestions:
One ZERO disciple suggested a cable winder.
Another realized that the camera hole in the battery could be used to carry cables.
We combined both ideas into a lightweight modular accessory that attaches directly to ZERO or can be used as a standalone.
You have 2 versions:
Small : Adapted for small cables.
Big : Deeper body for longer cables.
Feel free to resize to adapt to your needs.e.
FEATURES
snap-on mounting system
lightweight and low material usage
fast print time
clean cable routing
No supports required (recommended orientation)
remix-friendly geometry
modular attachment system
USE CASES
desk cable management
workspace organization
minimal setups
maker desks
portable setups
PRINT SETTINGS
Layer height: 0.2 mm
Material: PLA, ABS or PETG
Infill: 15–20%
Supports: not required
This project is part of the evolving ZERO ecosystem:
ZERO is a modular battery system shaped alongside its community.
We are releasing this design open source for makers to print, modify, and remix freely.
If you improve or remix it, share it with the community so the ecosystem evolves.