5 kg Spool Holder and Adjustable Support for ELEGOO Centauri Carbon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spool Holder and Adjustable Support for 5 kg Filament Spools
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 259
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
5 kg Spool Holder with Adjustable Support
I made this remix of creations by Uncle Jessy, rbliss, and Firstlayer Oy, to fit my newly bought 5 kg spool of SUNLU filament. Based on the update in the description of rbliss' spool holder support, I decided to make the support height adjustable using Firstlayer Oy's, adjustable feet. This spool holder and support, therefore, should fit Centauri Carbons with or without anti-vibration feet, and printers on uneven surfaces.
Dimensions:
The spool holder will fit spools with a width up to 170 mm (~6.7 inches). The adjustable support can be adjusted from a height of 165 mm to 195 mm.
Print:
Printed on the ELEGOO Centauri Carbon 1 with a 0.4 mm nozzle, in PLA @ 240°C.
The spool holder was printed in PLA, linewidth of 0.6 mm, 2 perimeters, layer height of 0.3 mm. Remember to remove the built-in supports. The spool holder has two groves for PTFE tubes, a nice addition but not necessary.
The spool holder support top and bottom were printed together by object. Printed in PLA linewidth of 0.6 mm, with 3 perimeters, and using a layer height modifier. The threaded parts of the support were printed with a 0.12 mm layer height following the recommendations of Firstlayer Oy, other layers were printed at a height of 0.3 mm.
Total print time 1h38m, ~100 g of filament used.