Tiny Paddle Support for Quansheng K1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Insert your N6ARA Tiny Paddle into this attachment and pop in in to your CW modded Quansheng K1 to add some stability
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 24
- Wydruki
- 2
- Wyświetlenia
- 325
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Printed on an Ender 3 pro with
PETG
230 degree nozzle 73 degree plate
20% infill
support enabled
If you flip the model so it prints with the side that touches the radio down to reduce supports you may end up with a tiny flange that needs to be trimmed off depending on your bed temp and initial layer settings. I think it prints better that way and hitting it with an x-acto is no biggie.
The tiny paddle goes in to this print SNUG. It's supposed to. On my paddle, the solder points where the 3.5 plug meets the board were a little long. I trimmed them down to slide into the print easier.
Info on modding your K1 here: https://github.com/briand/uv-k1-k5v3-firmware-custom/releases/tag/beta2