Sprinkler end for Menards watering can
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improved sprinkler end for a Menards 2 gallon watering can.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This is a replacement sprinkler cap for a Menards 2 gallon watering can. I purchased two of these resin cans this spring and was immediately disappointed with how the water just poured out of the bottom of the sprinkler. I increased the number of holes, reduced the hole size, and gave the sprinkler head a little room to build head pressure. The holes aren't perfectly concentric, but it seems to function much better.
1.5mm - 70 holes that are 1.5mm in diameter
73mm - Inside diameter where sprinker lid snaps on existing mount
5mm - The end that attaches to the can has 5mm of space before it butts up against the mount
4mm - There is a 4mm ring (inside diameter reduced to 65) to prevent sprinkler from sliding any further onto mount.
Printed in PLA using the QIDI slicer. The model uses 37.65g of filament. It will need support of some kind due to the retaining ring on the inside. I found that the "Normal 'snug'" support was easiest for me to remove after printing.