1 / 2
Automotive Clip (Dodge Dart II Hood) — zdjęcie 1
1 / 2

Automotive Clip (Dodge Dart II Hood)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

2013-2016 Dodge Dart (II) rubber hood trim clip.

Ocena
0 / 5
Polubienia
4
Pobrania
13
Wydruki
0
Wyświetlenia
103
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

2013-2016 Dodge Dart (II) has a rubber trim seal that latches to the hood. Popped the hood the other day to replace a faulty sensor and noticed about 20 of my trim clips had died...

Dodge wants to sell you the whole trim with clips together, only. The rubber was fine, so I modeled this nifty clip.

It's in two pieces to maximize layer strength. I tried to make a one-piece design, but it broke immediately because of the layer size and lack of adhesion, blah blah.

I would strongly encourage printing both pieces. To assemble, slide the disc through the thinnest part of the post before the clip's ^ shape. I did set my perimeters to about 8, and layer height is irrelevant.  I believe I also scaled to 105%, but 100 should work just fine.

EDIT: I redesigned the disc to have a square center post, which means it will not freely rotate when installed. I would definitely print this version. (I'm not going through the hassle to swap them out on the car...)

I used PETG and have had no issues so far. Maybe I'll need to redo it in ASA in a few years, but I hope by then the car isn't my problem!

Tagi