Automotive Clip (Dodge Dart II Hood)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2013-2016 Dodge Dart (II) rubber hood trim clip.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 13
- Makes
- 0
- Views
- 101
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
2013-2016 Dodge Dart (II) has a rubber trim seal that latches to the hood. Popped the hood the other day to replace a faulty sensor and noticed about 20 of my trim clips had died...
Dodge wants to sell you the whole trim with clips together, only. The rubber was fine, so I modeled this nifty clip.
It's in two pieces to maximize layer strength. I tried to make a one-piece design, but it broke immediately because of the layer size and lack of adhesion, blah blah.
I would strongly encourage printing both pieces. To assemble, slide the disc through the thinnest part of the post before the clip's ^ shape. I did set my perimeters to about 8, and layer height is irrelevant. I believe I also scaled to 105%, but 100 should work just fine.
EDIT: I redesigned the disc to have a square center post, which means it will not freely rotate when installed. I would definitely print this version. (I'm not going through the hassle to swap them out on the car...)
I used PETG and have had no issues so far. Maybe I'll need to redo it in ASA in a few years, but I hope by then the car isn't my problem!