Dongle with 1.3' display for ZMK (desk version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Promicro/Nicenano dongle with OLED display 1.3' and reset button. FDM-friendly, no supports required.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 379
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is the case for keyboard dongle with display and reset button. Not only receives signal, but also show you some useful info)
Hardware required:
Promicro/Nicenano nrf52840 controller - 1pcs
1.3 Inch I2C OLED Display Module 4pin (widely available on aliexpress)
SMD button 4*4*1.5mm (optional, cut 2 legs and solder it directly to RST and GND pins, as shown on photos)
m2 x 6-8mm screws - 2pcs
thin wires of your choise
bumpons 6mm - 4pcs (optional)
All the parts can be printed without supports. To install display cover, use its flexibility, you have to slightly bend it to snap in place.
I have also version of this dongle for mounting under monitor, which I personally like more, so check my other models.