Dongle with 1.3' display for ZMK (desk version)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Promicro/Nicenano dongle with OLED display 1.3' and reset button. FDM-friendly, no supports required.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 32
- Makes
- 0
- Views
- 379
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
This is the case for keyboard dongle with display and reset button. Not only receives signal, but also show you some useful info)
Hardware required:
Promicro/Nicenano nrf52840 controller - 1pcs
1.3 Inch I2C OLED Display Module 4pin (widely available on aliexpress)
SMD button 4*4*1.5mm (optional, cut 2 legs and solder it directly to RST and GND pins, as shown on photos)
m2 x 6-8mm screws - 2pcs
thin wires of your choise
bumpons 6mm - 4pcs (optional)
All the parts can be printed without supports. To install display cover, use its flexibility, you have to slightly bend it to snap in place.
I have also version of this dongle for mounting under monitor, which I personally like more, so check my other models.