Dongle with 1.3' display for ZMK (monitor version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Promicro/Nicenano dongle with OLED display 1.3' and reset button. FDM-friendly, no supports required.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is the case for keyboard dongle with OLED display and reset button. I find it convenient when it is attached to the bottom of the monitor, so it doesn't take the space on the desk and stays within your field of vision.
Hardware required:
Promicro/Nicenano nrf52840 controller - 1pcs
1.3 Inch I2C OLED Display Module 4pin (widely available on aliexpress)
SMD button 4*4*1.5mm (optional, cut 2 legs and solder it directly to RST and GND pins, as shown on photos)
m2 x 6-8mm screws - 2pcs
thin wires of your choise
piece of double-sided tape
All the parts can be printed without supports. To install display cover, use its flexibility, you have to slightly bend it to snap in place. To attach to monitor just use some double-sided tape.
I have also more "classic" version of this dongle for your desk, so check my other models.
