Replacement Desk Frame Spacer for ZE200 Electric Desk

Replacement spacer for a ZE200 electric desk frame.

This is a simple replacement spacer designed for a ZE200 electrically adjustable desk. The part sits between the metal desk frame and the wooden tabletop, where the tabletop is fixed from below with a screw passing through the frame.

I designed this part after one of the original spacers was lost during assembly. Instead of leaving the frame mounted directly against the tabletop, I quickly modeled and printed a replacement from TPU.

What it does

The spacer helps keep a small gap between the metal frame and the wooden tabletop. It also provides a more even contact point around the screw area and can help reduce direct metal-to-wood contact.

Features

• Replacement spacer for ZE200 electric desk assembly

• Fits between the metal frame and the tabletop

• Useful if one of the original spacers is lost or damaged

• Helps maintain proper spacing between frame and tabletop

• Simple and quick print

• Practical repair part for desk assembly or maintenance

Material recommendation

Print this part from a flexible or semi-flexible material if possible.

Recommended materials:

• TPU — best option if you want a rubber-like spacer

• PETG — acceptable if you only need a basic rigid replacement

• PLA — usable for a quick temporary fix, but less ideal long term

For the closest function to the original part, TPU is recommended.

Printing notes

Recommended settings:

• Material: TPU preferred

• Layer height: 0.16–0.2 mm

• Infill: 100%

• Supports: not required

• Print slowly if using TPU

• Make sure the screw hole prints cleanly

If printed from TPU, the part should remain slightly compliant when compressed between the frame and tabletop.

Installation

Place the spacer between the desk frame and the tabletop, aligned with the screw hole. Then fasten the tabletop from below using the original screw.

Do not overtighten the screw, especially when printing in a softer material. Tighten it enough to hold the frame securely without crushing or deforming the spacer too much.

Photo note

The photo shows the mounting area where the desk frame is attached to the tabletop. The spacer can be used between these two parts, around the screw connection.

Compatibility note

This spacer was designed for a ZE200 electric desk. Other electric or height-adjustable desks may use different spacer dimensions, screw sizes, or frame geometry, so check the fit before use.