X-Carve Suckit Dust Shoe Dial Indicator Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wanted a dial indicator mount for my X-Carve that didn't attach permanently and didn't conflict with my SuckIt Dust…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 268
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted a dial indicator mount for my X-Carve that didn't attach permanently and didn't conflict with my SuckIt Dust boot. this was designed from scratch and uses 4 neodymium magnets like the SuckIt shoe does so it mounts firmly by simply sliding it in the slot.
The magnets I used are 8mm diameter and 1mm thick and are super glued into the slots for them that align with the magnets in the SuckIt.
A single M4 bolt and nut hold the Dial Indicator to the mount. I designed it to use as little filament as possible and still have a strong structure.
If you need custom size or depth for the magnets let me know I will mod it for you. Although based on the design of the suckit max diameter for the magnet is about 9mm.
Print Settings
Printer:
Maker Select V2
Rafts:
No
Supports:
No
Resolution:
.3
Infill:
20%
Notes:
Print flat on the bottom, it saved with the bottom vertical when I exported it from Fusion 360. Just re-orient in your slicer.
Requirements
4 8mm X 1mm neodymium magnets, 1 M4 Screw or Bolt and 1 M4 Nut and Super Glue.
Designed in Fusion 360.
Category: Other