Hand Plane Blade and Chisel Sharpening/honing Sled/Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hand Plane Blade and Chisel Sharpening Sled/Jig
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is another rolling sharpening sled for plane blades, chisels and anything with flat faces and a pointy end.
This desing of mine is inspired in the cheap commercial solution you can buy from anywhere and in fauxhican's desing.
It can acomodate almost any size of blade within it's two set of slot as shown in the pictures (small 6mm chisel and large 50mm chisel) and the full aperture is customizable by using longer or shorter threaded rods.
You need to print 2 identical copies of this part, one for each side, as shown in the pictures. It's designed to be printed without supports at 0.2mm layer height, 4 to 5 perimeters and 20-30% infill.
For the assembly it requires the following METRIC hardware:
2 - M5-0.8 x 75 to 100mm (It's up to you) threaded rod.
2 - M5-0.8 nuts.
2 - M5-0.8 nuts drilled to 5mm (Used as busshing for the threaded rods).
2 - M5-0.8 wing nuts.
2 - M8-1.25 x 25mm Button Head Allen bolt.
2 - M8-1.25 Lock nuts.
4 - 8x13x0.8 mm (Or similar) shim washers.
2 - 608RS (Sealed) ball bearing.