Milwaukee Track Saw - Splinter Guard Jig - 130mm Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 3D printed jig for trimming the splinter guard on a Milwaukee track saw guide rail. The jig extends the saw’s s
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Open Community License v1
This jig was designed to help make a clean first cut on the splinter guard of a Milwaukee track saw guide rail.
When trimming the splinter guard, the saw can become unstable near the end of the track because the saw base starts to run out of support. This jig gives the saw just enough additional support at the end of the rail so the cut can continue cleanly without the splinter guard moving or tearing out at the end.
The jig is intended to be used when setting up or replacing the splinter guard on a Milwaukee track saw rail.
My Print Settings
Material: PETG
Infill: 15%
Supports: None
Layer Height: Standard layer height should work fine
Orientation: Print flat for best stability
Notes
Test fit before use.
Make sure the jig is seated securely before cutting.
This is a setup aid only.
Fit may vary slightly depending on printer calibration, rail condition, or saw model.