Aqara U200 smart lock front plate with USB-C cutout
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix version. A simple way to alternate the look of your Aqara U200 with USB-C cutout to power the lock.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix version of the 3D model that @Stony made for the Aqara U200 lock.
I did need a cutout section at the USB-C part to have always the option to power the Aqara lock if needed.
This is also handy to charge the lock, you do not need to remove the plate.
What I did:
I do have a HomeAssistant environment and made a automation that turns the power to the lock on when the lock is under 21% battery life. It turns off when the battery is at 80% battery. This way I never have to charge the battery that is inside the lock itself.
The keypad can be direct powered aswell, so I did.
To power the door lock I used this:
USB-C flat cable
https://nl.aliexpress.com/item/1005006208156665.html?spm=a2g0o.order_list.order_list_main.84.46b879d29X2mDE&gatewayAdapt=glo2nld
USB Power cable
https://nl.aliexpress.com/item/4001234393013.html?spm=a2g0o.order_list.order_list_main.11.46b879d29X2mDE&gatewayAdapt=glo2nld
With a charging block I still had laying around.
The original tip enable “Only one wall on first layer” in quality settings (Bambu Studio / Orca Slicer) for a cleaner look didn't work for me, maybe I had to set more settings different.
Original 3D model description:
A simple way to alternate the look of your Aqara U200 with a new front plate or cover.
Printing tipps:
enable “Only one wall on first layer” in quality settings (Bambu Studio / Orca Slicer) for a cleaner look
center and then rotate the part 135° in x-axis for vertical print lines.
use a structured print sheet for a very nice looking first layer which hides the layer lines completely
Installation front plate:
Put the two bottom guides into the matching openings first and make sure the lower mid lower taps fits underneath the lower battery holding tap. Then gently apply light pressure around the sides from the bottom to the top to press the cover in. I advice to support the U200 from the back to avoid the smart lock from tilting on the profile cylinder.
Installation cover:
First remove the front plate and then gently put the cover on.