Bidet Shower Toilet Tank Hanger Adapter (Cornat)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter to hang a Cornat bidet shower bracket directly onto a toilet water tank without drilling.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Public Domain
Overview
This is a simple, drill-free solution for mounting a bidet shower kit (specifically designed for the Cornat Waschbecken Brause-Set.
While these kits usually require drilling into the wall to mount the wand holder, this adapter allows you to hook the original bracket directly over the edge of your toilet ceramic reservoir tank.
Perfect for renters or anyone wanting a clean, non-destructive installation.
Hardware Needed
To assemble the adapter to the original plastic holder, you will need:
1x M4 Screw (an M4 countersunk or button head screw works best, length depends on your specific bracket depth, typically 8–10mm is sufficient).
1x M4 Hex Nut (7mm width across flats).
Assembly Instructions
Insert the Nut: Press the M4 hex nut into the integrated hexagonal pocket on the inner side of the printed hanger. The pocket is designed with a snug fit to keep the nut locked in place during tightening.
Align the Bracket: Line up the mounting hole of your original bidet wand holder with the 4.5mm clearance hole on the printed adapter.
Secure the Screw: Pass the M4 screw through the original holder and thread it directly into the embedded M4 nut. Tighten securely, but be careful not to overtighten and crack the plastic components.
Mount: Lift your toilet tank lid slightly, slide the hook over the rim of the ceramic reservoir, and place the lid back down to secure the hanger in place.
Print Settings Recommendations
Material: PETG or ASA (recommended for bathroom environments due to moisture resistance and durability).
Infill: 25% or higher (Grid or Gyroid) for mechanical strength where the hook takes the weight.
Walls/Perimeters: 3 to 4 lines to ensure the hook and screw interface are solid.
Supports: Not required if oriented flat on its side.