Universal Height-Adjustable Tow Hitch for Kids Electric Ride-On Cars (No Drill)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Universal Height-Adjustable Tow Hitch for Kids Electric Ride-On Cars (No Drill)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
An universal, height-adjustable heavy-duty tow hitch designed specifically for kids' electric ride-on cars (like Peg Perego, Ford Ranger, Jeep clones, etc.).
If your kids have different trailers from various brands, you know the struggle: the coupling heights never match. This smart design solves the problem by allowing you to adjust the hitch height seamlessly, so you can hook up any trailer in seconds!
### Key Features & Fitment:
- Tube Compatibility: Designed to clamp onto a 16 mm diameter metal tube/bar.
- No-Drill Design: Clamps directly onto the existing rear metal bar/bumper tube of the car. It won't damage the plastic chassis!
- Height-Adjustable: Quick-release pin mechanism to adapt to any trailer tongue height.
- Heavy Duty: Reinforced structural geometry to handle heavy pulling loads.
### Important Assembly Tip:
In the photos, you might notice a slight gap or curve on the top clamp part. This is because I placed a thick rubber strip underneath the clamp to prevent it from rotating on the metal bar. For a perfectly flush fit and excellent grip, I recommend using a slightly thinner rubber sheet/strip underneath.
### Hardware Needed:
- 4x M4 or M5 bolts and nuts for the main tube clamp (check the photos for reference).
- 1x Pin/bolt for the height lock mechanism.
### Printing Recommendations:
- **Material:** PETG, ASA, or ABS is highly recommended. Avoid PLA as it is too brittle for towing and can deform under hot sunlight.
- Perimeters/Walls: At least 4-6 walls for maximum strength.
- Infill: 35-50% (Gyroid or Grid pattern).
- Orientation: Print the main body standing or flat on its side, depending on your printer's layer adhesion strength. Support might be needed for the overhangs.
### Feedback & Community:
This is my first version, and I want to improve it further! Please leave a comment, share your makes, and let me know your thoughts. I would highly appreciate any constructive criticism and suggestions on what features to develop or tweak next!