1 / 3
Universal Height-Adjustable Tow Hitch for Kids Electric Ride-On Cars (No Drill) — image 1
1 / 3

Universal Height-Adjustable Tow Hitch for Kids Electric Ride-On Cars (No Drill)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Universal Height-Adjustable Tow Hitch for Kids Electric Ride-On Cars (No Drill)

Rating
0 / 5
Likes
1
Downloads
11
Makes
0
Views
139
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

An universal, height-adjustable heavy-duty tow hitch designed specifically for kids' electric ride-on cars (like Peg Perego, Ford Ranger, Jeep clones, etc.).

If your kids have different trailers from various brands, you know the struggle: the coupling heights never match. This smart design solves the problem by allowing you to adjust the hitch height seamlessly, so you can hook up any trailer in seconds!

### Key Features & Fitment:

- Tube Compatibility: Designed to clamp onto a 16 mm diameter metal tube/bar.

- No-Drill Design: Clamps directly onto the existing rear metal bar/bumper tube of the car. It won't damage the plastic chassis!

- Height-Adjustable: Quick-release pin mechanism to adapt to any trailer tongue height.

- Heavy Duty: Reinforced structural geometry to handle heavy pulling loads.

### Important Assembly Tip:

In the photos, you might notice a slight gap or curve on the top clamp part. This is because I placed a thick rubber strip underneath the clamp to prevent it from rotating on the metal bar. For a perfectly flush fit and excellent grip, I recommend using a slightly thinner rubber sheet/strip underneath.

### Hardware Needed:

- 4x M4 or M5 bolts and nuts for the main tube clamp (check the photos for reference).

- 1x Pin/bolt for the height lock mechanism.

### Printing Recommendations:

- **Material:** PETG, ASA, or ABS is highly recommended. Avoid PLA as it is too brittle for towing and can deform under hot sunlight.

- Perimeters/Walls: At least 4-6 walls for maximum strength.

- Infill: 35-50% (Gyroid or Grid pattern).

- Orientation: Print the main body standing or flat on its side, depending on your printer's layer adhesion strength. Support might be needed for the overhangs.

### Feedback & Community:

This is my first version, and I want to improve it further! Please leave a comment, share your makes, and let me know your thoughts. I would highly appreciate any constructive criticism and suggestions on what features to develop or tweak next!

Tags