Remixed Xshot MPP shroud Motorized Piston Pump
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Combines elements of three other things
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 34
- Wydruki
- 1
- Wyświetlenia
- 335
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a little hard to explain but here goes.
This remix combines the basic shroud from Spyder's thing: https://www.printables.com/model/1379053-spyders-mpp-front-shroud-x-shot-aeb-motorized-pist
with the top and bottom rails from https://makerworld.com/en/models/1844886-atlas-srs-hand-guard-for-the-xshot-mpp (because I wanted the long continuous top rail)
and clears out some hollow space in the front like https://www.printables.com/model/1649341-spyders-mpp-short-king-opened-front
but leaves in more of the original ~33mm hole for the barrel collet.
This remix is intended to:
be really strong
provide a lot of rail
The "no side rail" version should be compatible with the side decorative pieces from the original Spyder version but I haven't tested it.
The "Atlas rear rail" is modified only slightly from the original from atlasunit22. Basically it has a groove down the center like the other rails.
I do believe you'll need supports on the inside of the round part. Also for this piece, I used a brim on the build plate since relatively little of the model touches it, but you may not need that.