(Bigger) CONDENSATION TRAY for Midea PortaSplit | REMIX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two versions: 26x20cm & 20x20cm | rounded edges | some modifications for better and WATERTIGHT printing
- Ocena
- 4,5 / 5
- Polubienia
- 24
- Pobrania
- 369
- Wydruki
- 2
- Wyświetlenia
- 1504
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
(Bigger) CONDENSATION TRAY for Midea PortaSplit | REMIX
This is a remix of the great original tray-model for the Midea-PortaSplit with now rounded edges, 2 different sizes & some modifications for better and WATERTIGHT printing! And PETG ftw!
Two versions: 26x20cm & 20x20cm


For easier and waterproof printing of the walls, there is an integrated cylinder and a bevel at the plate/wall connection. Place the seam at the cylinder (inside & outside). See in the pictures below! Print the model with 100% Infill or a high number of bottom layers, so the chance of a watertight baseplate will be higher! Good luck & again, PETG ftw!



note: USE THIS TRAY ONLY FOR RELEASING THE WATER TEMPORARY - THIS IS NOT A FIXED SOLUTION! If it is not waterproof, you can try some sealants or seal sprays.