(Bigger) CONDENSATION TRAY for Midea PortaSplit | REMIX
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two versions: 26x20cm & 20x20cm | rounded edges | some modifications for better and WATERTIGHT printing
- Rating
- 4.5 / 5
- Likes
- 24
- Downloads
- 369
- Makes
- 2
- Views
- 1,504
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
(Bigger) CONDENSATION TRAY for Midea PortaSplit | REMIX
This is a remix of the great original tray-model for the Midea-PortaSplit with now rounded edges, 2 different sizes & some modifications for better and WATERTIGHT printing! And PETG ftw!
Two versions: 26x20cm & 20x20cm


For easier and waterproof printing of the walls, there is an integrated cylinder and a bevel at the plate/wall connection. Place the seam at the cylinder (inside & outside). See in the pictures below! Print the model with 100% Infill or a high number of bottom layers, so the chance of a watertight baseplate will be higher! Good luck & again, PETG ftw!



note: USE THIS TRAY ONLY FOR RELEASING THE WATER TEMPORARY - THIS IS NOT A FIXED SOLUTION! If it is not waterproof, you can try some sealants or seal sprays.