Core One +/L Screen Cover and Dust Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sleek tight fitting screen cover with a little dust shield for the gap between the body and the screen
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 57
- Wydruki
- 2
- Wyświetlenia
- 182
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Made this screen cover with the sole purpose of having the door be openable with it on. While designing it I also wanted to make it as good as I could, so I made it fit tightly, without much (if any) play, but still be easy to remove, and made it follow the lines of the stock xLCD cover. The door should have about 1mm of clearance with the cover on (about 2mm without).
The dust shield is very simple, it's just a triangle and it has a small indentation where you can add a bit of thin double sided tape (it doesn't need to be super strong, just to hold it in place), that I made because I got annoyed at the very small gap between the screen and the body that was a bit hard to clean. It is small because I wanted it to look unobtrusive.
The screen cover has 2 options, either the regular (C1_Screen_Cover) or one with a cutout for the dust shield (C1_Screen_Cover_dust_shield_cutout).