One handed jar opener

After a shoulder operation i realised simple tasks like opening a jar where really tough, near on impossible. I have another operation on the same shoulder in 6 weeks, so I made this one handed jar opener using ABS & 95A TPU, its possibly a little over engineered but one thing for sure it shouldnt break, and works really well.

I show the print orientations i used in the pictures, along with further settings below. These ensure more than adequate strength. 

Super glue is required (weights and clamps used to ensure glued surfaces adhere well and TPU parts adhere in correct shape).

My Settings: *Prusa slicer default unless stated.

ONE HAND OPENER BASE V2 - ABS (PETG should be fine). 15% infill - gyroid, 5 perimeters, organic supports. Note print orientation to ensure max strength across yield points.

ONE HANDED OPENER STEADY -  ABS (PETG should be fine). 15% infill - gyroid, 4 perimeters, snug supports. See print orientation picture. Glue to recess on base.

JAR OPENER HANDLE - ABS (PETG should be fine). 5% infill - gyroid, 4 perimeters, snug supports. See print orientation picture.

BASE TPU1 - 95A TPU - See print orientation picture. Glue on to base 1st. 

BASE TPU2 - 95A TPU - See print orientation picture. Glue on to base 2nd.

BASE TPU3 - 95A TPU - See print orientation picture. Glue on to base 3rd.

BASE TPU4 - 95A TPU - Turn on fuzzy skin in prusa slicer for extra grip. See print orientation picture. Glue on to base last.

HANDLE TPU1 V2 - 95A TPU - See TPU support settings picture (to ensure easily removable supports). See print orientation picture. Glue on to handle 1st.

HANDLE TPU2 - 95A TPU - Turn on fuzzy skin in prusa slicer for extra grip. See print orientation picture. Glue on to handle (in situ- last).

Designed for 45-100mm diameters jars.