IIDX LM LED Strip channels

EDIT 19/09/2026: Made compane channels a bit thinner so the front door can fit below withouth too much effort and potentially breaking the channel. Might still need to try to make them thinner...

Various LED strip channels for a converted beatmania IIDX cabinet, especifically designed for a Tricoro cabinet.

The different channels are meant for each part of a IIDX LM cabinet lightning system, consisting of WS2812B LED strips. They were designed around 2020 LEDs on a 5mm wide tape but probably the diffusers can hold bigger tapes.

Available channels, with difusser model and LED density, are:

• COMPANE: T0511, 60led/m

• TP SIDE: D1313 180º, 100led/m 

• PILLAR: B2010, 100led/m (WIP)

• SIDE: B2010, 100led/m (WIP)

Models for UPPER are designed differently and uploaded independently:

• Top speaker LED channels: 

• E11 socket supports: 

Some indications:

• The 34cm channel for COMPANE is meant to be set below the deck and at the center of length, for this it was designed to use the M5 that can be found below the deck too. If your printer is big enough, try to print the 40cm model since it you happen to use a longer/less dense strip

• The 20cm channel for COMPANE is also meant to support longer strips, designed to be held by only one M5 screw.

• For the TP SIDE channels there are some trims that you can use to hide strip wires if you want and fit the diffuser tightly, if the strip you use is short enough.

All of these prints have been made with Elegoo PETG PRO.

Printing settings:

• Sparse infill pattern: Gyroid

• Supports: Enabled

  • On build plate only: Enabled

• Brim-object gap: 0.2mm

Filament settings for Elegoo PETG PRO:

• Max volumetric speed: 14m/s

• Nozzle temperature: 260ºC

• First layer nozzle temperature: 265ºC

• Pressure advance: 0.06mm

• Retraction length: 0.6mm