1 / 5
House Fly Trap for Large Mouth Mason Jar — zdjęcie 1
1 / 5

House Fly Trap for Large Mouth Mason Jar

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Works on any large mouth Mason Jar and reusable. Just add some water and choice of meat or fish oil.

Ocena
0 / 5
Polubienia
8
Pobrania
103
Wydruki
0
Wyświetlenia
433
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

After many downloads, trials, and errors, finally just reengineered one with the most effective traits that is also easy to print. I found flies seem to get confused by the walls in the middle and a ceiling vs an open top and escape way less frequently.

For bait I've had a lot of luck with a little water (1/4-1/2 cup or 60-120ml), some fish oil (cheap fish oil supplements or other fish products like anchovies or fish meal are popular suggestions), and a piece of raw chicken, pork, or fish. It may take a day or two to really stink, but it can get overwhelming if not in a very open area. If it dries out just rinse and repeat or simply add some water back into the jar.

These get VERY nasty so remember to be careful when disposing of the remnants and keep away from pets!

Any suggestions and feedback are welcome. Thanks!

Depending on your tolerance the top should snap into the bottom fairly securely.

Print Settings:

Printer: Qidi Plus 4
Filament: Oveture PLA Pro (If using outside use appropriate filament, the sun melts PLA!)
Layer height: 0.2mm
Infill: 100% (Shouldn't actually matter.)
Support: None

Also available on Thingiverse: https://www.thingiverse.com/thing:7336201

Tagi